Vetonit Putty WR is composed of white cement, fine fillers, bonding chemicals, and high-performance additives. It is supplied as a dry powder in pre-weighed bags ready to use on-site. It only requires the addition of clean water to produce a cohesive mix. Vetonit Putty WR is a high-quality product applied as a thin underlayment to repair undulations. It provides a very smooth surface finish that is ideal for subsequent application of paint and decorative coatings. Vetonit Putty WR can be applied generally in thickness from 1mm to 3mm.

USES

• Use to leveling of minor surface undulations.
• Apply externally & internally, in wet and dry conditions, onto the walls & ceilings such as Bathrooms & Kitchens
• Use on concrete and plastered surfaces that are smooth, and also on precast concrete surfaces.
• Suitable for use over surfaces that are plastered with Saveto products and on gypsum boards.

ADVANTAGES

• Factory controlled pre-blend that ensures consistently high quality.
• Requires only the addition of water on-site at the time of usage.
• Suitable for external & internal applications.
• Water-resistant.
• Easy to apply, requires minimum effort to achieve a superior finish.
• Strong adhesion on a variety of substrates.
• Use on concrete and plastered walls & ceilings.
• Achieves a very smooth finish.
• Suitable for humid & dry conditions.

Vetonit Putty WR is supplied in 20kg Bags.

MIXING

For mechanical mixing, add to the mixing container 7.6-8 liters of water for each 20kg bag of Vetonit Putty WR. Add the powder to the water and mix with a mechanical plaster mixer, or with a low-speed electric drill fitted with a suitable paddle. Mix for 3-4 minutes until achieving a  uniform, lump-free consistency.

Leave the mixed material to stand for 10 min and briefly remix without adding water.

Mix small batch quantities manually for approximately 1-2 min, or until achieving a when a homogenous mix.

When required, add 1 liter of Vetonit Bond 2 to the mixing water and adjust the water requirement for each 20kg bag of Vetonit Putty WR accordingly. Follow the same mixing procedure as above.

Use the mixed material within 3 hours. Do not add water once the mixed filler mortar starts to stiffen or harden.

APPLICATION

Generally, apply Vetonit Putty WR is in single or double coats.

Apply Vetonit Putty WR to the substrate by pressing the putty firmly onto it. Use a flat trowel to level the material to a smooth finish.

Apply a second coat if necessary once the first coat initially sets.

After applying Vetonit Putty WR, it is recommended to apply one coat of alkali-resistant primer followed by two coats of acrylic emulsion paint or other suitable coatings.