Premix Plaster PLS222 is a cement based plastering material composed of hydraulic binders (OPC), selected graded aggregates, fi bers, and special additives. It is supplied as a dry powder in pre-weighed bags ready to use on site, which requires only the addition of clean water to produce cohesive mortar. PlasterMix-S PLS222 is specially designed for application by spray machine and contains special shrinkage control additive and provides good adhesion with uniform color surface. PlasterMix-S PLS222 can be applied at thicknesses ranging from 10 mm to 20 mm.

Advantages
 Fast mixing application using spray machine
 Applied directly on AAC and normal block walls
without the need for key coat.
 Factory controlled pre-blend ensures consistent
high quality.
 Requires only addition of water on-site at the
time of usage.
 Improved workability & curing.
 Easy application with uniform work flow enables
high productivity & superior finishing.
 Strong adhesion on variety of substrates.
 Internal & external applications.
 Shrinkages control reduces surface cracks.
 Suitable for humid & dry conditions.
 Suitable for vertical & ceiling surfaces.
 Free from Asbestos, very low VO

Usage Instructions

Surface Preparation
Substrate should be sound, clean, free from loose material, grease, laitence, dirt, curing compound, or any other substance that might impair the quality of bond with the substrate. Prior to Plaster Application, wet the entire surfaces with clean potable water. The substrate should be saturated surface dry at the time of Plaster application.

Mixing 
Add to the mixing container 6.5 to 8 liters of water for each 50 Kg bag of Plaster. Add the powder to the water and mix with a mechanical plaster mixer or low speed electric drill fitted with a suitable paddle for 3-4 minutes, until a uniform, lump-free consistency is achieved.
For application using Saveto plastering machine, the water fl ow rate is 300 – 400 Lit / hour. Monitor condition of rotor stator as it affects the water ratio. Mixed material should be used within 90 min.
Do not add water to the mix once the mixed mortar start to harden.

Smooth Concrete Surfaces/Thick Plaster
Apply Spatter Dash at 4 to 6 mm thickness and allow to cure sufficiently prior to the application of PlasterMix-S PLS222.

Application
PlasterMix-S PLS222 can be applied in a single or multiple layers on rough surfaces. On smooth concrete surfaces (and thick paster > 20 mm.) it should be applied subsequent to the application of a spatter- dash coat.    Rod or level to a uniform thickness immediately then follow smoothing the material to the desired appearance.                                                                                                                                                                                    For multiple layers allow the first plaster layer (15 mm.) to cure for 2-3 days. Apply next layer at thickness not more than 15 mm.                                                                                                                                                 After the surface appears stiff but still moist, follow the smoothing the material to achieve the desired appearance.
For plastering ceilings, it is recommended to use vetonit Render

Curing
PlasterMix-S PLS222 is best cured by spraying water on its surface every 8-12 hrs for a minimum of 3 days. During hot & dry conditions allow curing for minimum of 7 days. It will help to obtain high mechanical strengths and minimize the risk of surface cracks.